Skip to content
Studio
All modules

Routster Studio

Course generator

Premium With a Routster Premium or Club plan, or the free trial.

Proposes whole sprint courses built from legs where the runner really has a choice, or a set of courses that share controls.

What it does

On a sprint map it searches for legs with a real route choice and joins them into a course that starts and finishes where you placed the start and the finish. You say how long the course should be and how many controls it has, and let it search. It offers several courses, each with its length and its number of legs.

Every leg it proposes is measured with Analyse's router, so a route choice it offers is one the runners will really have. Measure it gives the course's length and how many of its legs have a real choice, and marks each leg as a choice or as one with no route.

The rules behind a proposal are yours to change under the advanced settings: what counts as a short or a long leg and how many of each a course needs, the shortest and longest leg, how close two controls may be, the smallest and largest angle at a control, how many of the legs may be plain connectors, when a leg counts as a choice and how much longer an alternative may be and still count, and how far the last control is from the finish. When nothing meets the rules, its notes say what was in the way.

It can also build a set of courses that share controls, and a control another course already uses is worth more to the search. Create this course takes the proposal you like into the event as a course, and Create all does the same for the whole set.

How you use it

  1. Open an event with a sprint map, and place a start and a finish on a course. The generator reads them from the course on screen.
  2. Open the module's page and set how many controls the course has and how long it should be.
  3. Open the advanced settings if you want to change the rules. Back to the defaults puts them back.
  4. Press Generate and wait. The search takes a while.
  5. Look at what it offers, press Measure it on the one you like, and read how many legs have a real choice.
  6. Press Create this course. It becomes a course of the event, and the one showing.
  7. Check it on the map, and with the checks in the other modules, as you would a course you drew yourself.

What it needs, and what it does not do

  • It works on sprint maps only, because it reads the map's sprint mask. A map without one has nothing to generate on.
  • Two edge cases are known. With a finish it cannot reach, the search can keep working without saying so. With no start or finish on the course on screen, it can put controls in the blank part of the map's bounding box, off the drawn map. Look at a proposal on the map before you take it.
  • A proposal is a starting point. A real route choice is not the same as a fair or a good leg, and that judgement stays with the setter.